ACMOSIL 36-4696

Sprayable Release Agent Solution of silicones in a mixture of solvents

Advantages:

Excellent release

Minimal cleaning stops

Economic in use

Processing:

Contents of drum must be well stirred before and during use. The Release Agent should be at room temperature before processing. We recommend using needle-controlled air-assisted spray-guns. At normal cycle times the material output should be about 10 – 50 ml/min. This can be achieved by using nozzles of a diameter of 0,3 mm and an appropriate material pressure. Before first coating is applied the mould should be cleaned with an ACMOSOL Mould Cleaner. New or cleaned moulds should be sealed with the Release Agent two or three times before filling.

Storage:

Stir up thoroughly before use.Do not store outdoors. Protect from heat and cold. To use only under permanent stirring. Allow products to reach room temperature before use. Storage temperature: between 10° C and 30° C Maximum storage: approx. 18 months (originally sealed container)