Acmoscoat 3-1020-1

Sprayable, semi-permanent, water-based, rotomoulding PE coating

Advantages:

Excellent separating properties

Minimal cleaning intervals

Economical to use

Matt surface

Without having to run an empty cycle for polymerization.

Procedure:

Before the first use, after mechanical cleaning, the molds should be cleaned with ACMOSOL 130-22 mold cleaning agent. A good and long-lasting release coating can only be achieved on clean mold surfaces.

The first 3-5 coats of Acmoscoat 3-1020-1 should be applied thinly and evenly using a cloth or spray technology. Where the mold temperature exceeds 60 ° C, spray application is required. It is necessary to wait for the coating to dry (waiting time between coatings 3-5 minutes) and for the water to drain off. The mold can be used immediately after drying.

One or two additional coatings of Acmoscoat 3-1020-1 can be applied with decreasing release properties. Additional layers can only be applied to dry and dull areas.

Storage:

Stir thoroughly before use. Do not store outdoors. Protect against extreme temperatures. Keep stirring while using. The product should be at room temperature before use.