ACMOSIL 36-4614

Sprayable Release Agent Dispersion of waxes and silicones in isoparaffines

Advantages:

Excellent release
Minimal cleaning stops
Economic in use

Processing:

Contents of drum must be well stirred before and during use.
The Release Agent should be at room temperature before processing.
We recommend using needle-controlled air-assisted spray-guns.
At normal cycle times the material output should be about 30 – 50 ml/min. This can be achieved
by using nozzles of a diameter of 0,3 mm and an appropriate material pressure.
Before first coating is applied the mould should be cleaned with an ACMOSOL Mould Cleaner.
New or cleaned moulds should be sealed with the Release Agent two or three times before filling.

Storage:

Stir up thoroughly before use.Do not store outdoors. Protect from heat and cold. To use only under permanent stirring.
Allow products to reach room temperature before use.
Storage temperature: between 10° C and 30° C
Maximum storage: approx. 18 months (originally sealed container)

Please check for material compatibility before use!
Additional information can be found in the ACMOS EU safety data sheet.
Our Sales and Technical Department are always at your disposal to answer technical queries.
Bremen, 22.09.2017
All information given is accurate to the best of our knowledge but do not exempt from your own testswith regards to its aptitude for the
intended purposes. Application, use and processing are done outside our control and must therefore be exclusively the responsibility
of the end user.