Minimal cleaning stops
Economic in use
Dry foam surface, gluing without pretreatment in most cases possible
The Release Agent should be at room temperature before processing. The contents of drum must be well stirred before use.
We recommend to use an appropriate, low speed stirrer for 10 – 20 minutes. This procedure should be repeated for 5
minutes at least every 4 – 5 hours.
We suggest using needle-controlled air-assisted spray-guns.
At normal cycle times the material output should be about 60 – 120 ml/min. This can be achieved
by using nozzles of a diameter of 0,5 – 0,8 mm and an appropriate material pressure. We recommend a thin and uniform
application to avoid foam surface disturbances.
Before first coating is applied the mould should be cleaned with an ACMOSOL Mould Cleaner.
New or cleaned moulds should be sealed with the Release Agent two or three times before filling.
Stir up thoroughly before use.Do not store outdoors. Protect from heat and cold. Allow products to reach room
temperature before use. Do not leave container open.
Storage temperature: between 10° C and 30° C
Please check for material compatibility before use!
Additional information can be found in the ACMOS EU safety data sheet.
Our Sales and Technical Department are always at your disposal to answer technical queries.
All information given is accurate to the best of our knowledge but do not exempt from your own testswith regards to its aptitude for the
intended purposes. Application, use and processing are done outside our control and must therefore be exclusively the responsibility
of the end user.