Henax | ACMOSIL 10-501
17476
page-template-default,page,page-id-17476,cookies-not-set,ajax_fade,page_not_loaded,,vertical_menu_enabled,side_area_uncovered_from_content,qode-theme-ver-8.0,wpb-js-composer js-comp-ver-5.5.1,vc_responsive

ACMOSIL 10-501

ACMOSIL 10-501

Universally applicable Release Agent for nearly all purviews in handling rubber

PROPERTIES:

Release Agent concentrate, dilutable with water

ADVANTAGES:

Suitable for nearly all kind of rubbers

Resistant to high temperatures

Excellent release properties even under difficult conditions

Excellent gliding properties

PROCESSING:

The contents of the drum must be well stirred.

During preparation of the ready-to-use Release Agent and during its application a continuous and slow stirring is necessary. Add always the water to the concentrate – not vice versa !

Before processing the Release Agent must be at room temperature.

Before first coating is applied the mould should be cleaned with an ACMOSOL Mould Cleaner. Before first foaming the Release Agent should be applied two or three times and allowed to flash off before each coat to give a good base coating.

The Release Agent can be diluted with water between 1 : 5 and 1 : 10. The hardness of the water should not exceed 7ş dH. The best dilutions will be achieved by using de-mineralized water.

Processing temperature: min. 10ş C.

STORAGE:

Stir up thoroughly before use. Do not store outdoors. Protect from heat and cold. To use only under permanent stirring. Allow products to reach room temperature before use.

Storage temperature: between 10° C and 30° C.

Maximum storage: approx. 6 months (originally sealed container)