Sprayable solvent-based Release Agent
The Release Agent is free from silicone !
Minimal cleaning stops
Economic in use
The content of the drum must be well stirred before and during use.
The Release Agent should be at room temperature before processing.
Before first coating is applied the mould should be cleaned carefully.
The Release Agent can be applied by hand (paintbrush/cloth) or by spray gun. Before polishing the mould surface the release film has to be dried on.
New or cleaned moulds should be sealed with the Release Agent two or three times before filling. the mould to give a good base coating.
Stir up thoroughly before use. Do not store outdoors. Protect from heat and cold. Allow products to reach room temperature before use.
Storage temperature: between 10° C and 30° C.