Henax | ACMOS 118-228
16588
page-template-default,page,page-id-16588,cookies-not-set,ajax_fade,page_not_loaded,,vertical_menu_enabled,side_area_uncovered_from_content,qode-theme-ver-8.0,wpb-js-composer js-comp-ver-5.5.1,vc_responsive

ACMOS 118-228

ACMOS 118-228

Release agent for removal from green sand (bentonite mass)

PROPERTIES:

ACMOS 118-228 has been specially developed for separating mouldings from greensand moulds. The parting agent film is highly resistant to heat and moisture and has good slip properties, so that adhesion of sand can be largely avoided. The contours of the mouldings remain sharp, and no damage occurs to the bentonite formation.
ACMOS 118-228 is a solvent-free parting agent with good wettability.

APPLICATION:

ACMOS 118-228 should be used undiluted, in the as-delivered condition. The parting agent should be applied thinly and evenly. If it is applied expertly by hand or with a spray system, a single application is usually sufficient for several mould separations.

SUPPLY FORM:

Non-returnable drums containing 20 kg or 160 kg net.

Additional information can be found in the EU safety data sheet.

Our technical service department will gladly advise you on all questions concerning the application of our products. Free samples can be made available to you on request.

All information given is accurate to the best of our knowledge but provided without guarantee.